Lorby-SI
  • Home
  • NEWS
  • Products
  • Where to buy
  • Downloads
  • Contact us
  • Privacy Policy

Lorby AxisAndOhs released

12/23/2018

3 Comments

 
Hello @ll,

I have decided to release the current development version of "Lorby AxisAndOhs" as freeware.

This app is an external, stand-alone tool, that manages joystick/controller assignment and calibration for your individual aircraft in the simulator. All joystick input is routed through the tool and injected into the simulator from the outside, so it is necessary to disable the controllers in the simulator itself (and in FSUIPC if you are using that).

The tool supports creating templates that you can assign to new aircraft, but every configuration is currently assigned individually to each single aircraft.

AxisAndOhs does not change anything in your simulator setup, it is completely external. (unless you use the feature that disables controllers in the standard.xml)
​
The app is still in development. I made it so that it fits my own use cases, as a casual simmer, who doesn't have a lot of time to fly. Also, I am always using only one aircraft with my favorite livery from an addon, I don't have the requirement to constantly change things. But of course people are approaching the same problem from different angles, so suggestions to improve the app are always welcome. 
3 Comments
Gilles Cuzin link
8/21/2020 07:20:54 am

problème avec saitek x52

Reply
John Manutes
9/2/2020 01:43:40 pm

Just installed the first update to MSFS 2020 and the panels no longer seem to work for me. Axis and Ohs did the job (thank you!!) before the update but now it doesn't seem to be working. Has this been reported to you by others as well? Is there a fix I need to do?
Thank you.
John

Reply
Lorby-SI link
9/2/2020 10:28:36 pm

There weren't any other reports about non-functional panels, so I assume that they work for most users. Make sure to check the configuration after every update. If the problem persists, please consider using the contact form on this side or send an email. Address is on the last page of the users manual.

Reply



Leave a Reply.

    News

    This page shows product news and information about current development streams

    Categories

    All
    Product Release

    RSS Feed

Proudly powered by Weebly
  • Home
  • NEWS
  • Products
  • Where to buy
  • Downloads
  • Contact us
  • Privacy Policy