AxisAndOhs 2.21 released

Hello @ll

version 2.21 has just been sent to the shops. It should be deployed shortly.

• Main change 1: GUI redesign of the Button and Axis assignment dialogs
  ​
  
• Main change 2: MSFS: Mapping BVars to LVars: This is an experimental feature that hacks into the MSFS input event logic to bind B: input events to LVars of your choice, so you can call these input events from RPN scripts.
  
  
• Change: Desktop FIPs are shown in the task bar now.
• Change: Direct input option in the down/up numerical controls of the button dialogs.
• Change: RPN: reading flight plan data into LVARs
• Change: RPN: option to access local LVars anywhere as macros with @lvar
• Change: RPN: check for self calling script reworked
• Change: RPN: added (RANDOMSOUND) command
• Change: RPN: clicking on a script group in the treelist selects it in the editor
  
  
• Bugfix: Exception when re-assigning midi axis
• Bugfix: After creating a new script, the “Update” button is now activated
• Bugfix: Saitek Multipanel could dial in negative altitudes
• Bugfix: RPN: One-shot autoscripts were not reset when a plane is loaded

About the BVars… this feature is a little more involved than usual and strictly experimental. It will probably not work for all BVar implementations out there (but there is a work around described in the manual if it doesn’t)
Please make sure (!) to read the chapter about that in the AAO manual for MSFS. Also, it may be a good idea to run AAO “As Administrator” when creating configurations with the BVar module.